Crankshaft Position Sensor: Testing and Inspection

CRANKSHAFT POSITION SENSOR
Resistance Inspection:
1. Disconnect the crankshaft position sensor connector.




2. Measure the resistance between terminals A and B by using an ohmmeter.

Specification: 950 - 1250 fl [20 °C { 68 °F }]

3. If not as specified, replace the crankshaft position sensor.

Air Gap Inspection:




1. Measure the air gap between crankshaft pulley and crankshaft position sensor by using a feeler gauge.

Specification: 0.5 - 1.5 mm (0.020-0.059 in)

2. If not as specified, replace the crankshaft pulley or the crankshaft position sensor.
Service and Repair