Crankshaft Position Sensor: Testing and Inspection

INSPECTION
Resistance
- Disconnect the crankshaft position sensor connector.
- Measure the resistance between terminals A and B by using an ohmmeter.

Specification: 500 - 600 ohms @20°C (68°F)

- If not as specified, replace the crankshaft position sensor.




Air Gap
- Measure the air gap between the crankshaft pulley and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5 - 1.5 mm (0.020 - 0.059 in.)

- If not as specified, replace the crankshaft pulley or the crankshaft position sensor.