Throttle Full Close Switch: Testing and Inspection
Closed Throttle Position Switch1. Verify that the throttle valve is at the closed throttle position.
Closed Throttle Position Switch (Part Of Throttle Position Sensor):
2. Disconnect the throttle position sensor connector.
Closed Throttle Position Switch Testing:
3. Check for continuity between throttle position sensor connector terminals C and D by using an ohmmeter.
4. If no continuity, adjust the throttle position sensor.
Closed Throttle Position Switch Throttle Gap Testing:
5. Insert a 0.50 mm (0.020 in.) feeler gauge between the Throttle Adjusting Screw (TAS) and the throttle lever. Verify that there is no continuity.
6. If there is continuity, adjust the throttle position sensor.