Vehicle Speed Sensor: Service and Repair

VEHICLE SPEEDOMETER SENSOR REMOVAL / INSTALLATION (GF4A-EL)
1. Disconnect the negative battery cable.
2. Remove the air cleaner component, battery, and battery carrier.
3. Disconnect the vehicle speedometer sensor connector.
4. Remove the vehicle speedometer sensor.
5. Apply ATF to a new O-ring and install it on a new vehicle speedometer sensor.
6. Install the vehicle speedometer sensor.

Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 69.5 - 95.4 inch lbs.)

7. Connect the vehicle speedometer sensor connector.
8. Install the battery, battery carrier, and air cleaner component.
9. Connect the negative battery cable.