LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2002 >> MPV ES >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Sliding Door >> Power Sliding Door (PSD) Control Module Removal/Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Sliding Door (PSD) Control Module Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the rear side trim.
  3. Remove the woofer. (LH only.)
  4. Remove the nuts, and screw.
    Fig 1: Removing Power Sliding Door (PSD) Control Module
    G01196306Courtesy of MAZDA MOTORS CORP.
  5. Remove the PSD control module.
  6. Disconnect the PSD module connector.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals