LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2003 >> B4000 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Module Communications Network) >> Self-Diagnostic System >> Equipment Hookup
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Equipment Hookup

WARNING: This page is about a different car, the 2001 Mazda B4000, 2001 Mazda B3000, 2001 Mazda B2500, and 2001 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off. Select proper program card for New Generation Star (NGS) tester (49-T088-0A0) for vehicle application. With NGS tester facing away from you, insert program card into tester. Ensure program card is properly inserted into NGS tester or tester will not operate.
  2. Connect NGS tester to Data Link Connector (DLC). DLC is located below driver's side of instrument panel, to right of steering column. Connect NGS tester power cable to battery source or cigarette lighter.
  3. Turn ignition switch to ON position. NGS tester automatically performs an initialization test. Initialization test checks the tester memory and verifies that vehicle interface module matches program card for tester. Perform data link diagnostic test. See DATA LINK DIAGNOSTIC TEST . Correct any faults as necessary.
  4. The menu item VEHICLE AND ENGINE SELECTION should be highlighted on scan tool. Press trigger to select VEHICLE AND ENGINE SELECTION.
  5. Rotate dial on NGS tester to menu item SELECT NEW VEHICLE MODEL AND YEAR, and press trigger to select. Select model year, vehicle and engine size by rotating dial to highlight the selection, and press trigger to select. If selected vehicle is not displayed, repeat this step.
scientia non olet · About LEMON Manuals