Using the Cruise Set Indicator Light
NOTE:
- The cruise set indicator light will illuminate for 3 seconds , when condition detection mode is on.
- If the RESUME/ACCEL switch on the cruise control switch is malfunctioning, the cruise set indicator light will not give a correct indication when you inspect the system. Use the SST (WDS or equivalent) to determine the cause of the malfunction.
- Drive the vehicle at 16 km/h {10 mph} or more.
- Operate each of the cruise control switches.
- Stop the vehicle and let it idle.
- Turn on the cruise control main switch (1).
- Turn and hold the RESUME/ACCEL switch on for at least 3 seconds
(2). The cruise set indicator light will illuminate for 3 seconds
, and then go off for at least 2 seconds
. Thus, the condition detection mode begins.
- If a DTC is indicated, inspect the corresponding system area.
- If normal, DTC(s) will not be indicated.
- The condition detection mode is canceled by turning the ignition switch to LOCK position or turning off the cruise control main switch.