Key Interlock Solenoid Inspection

Disconnect the negative battery cable.
Remove the column cover.
Disconnect the key interlock solenoid connector.
Insert the ignition key in the key cylinder.
Inspect the key interlock operation when B+ is applied to the terminal as shown.
- If not as specified, replace the key interlock solenoid.
Fig 1: Inspecting Key Interlock Solenoid (1 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 2: Inspecting Key Interlock Solenoid (2 Of 2)
Courtesy of MAZDA MOTORS CORP.
Install reverse order of removal.
Connect the negative battery cable.