LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2004 >> B2300 Base, Automatic >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Power Window Motor Removal/Installation >> Removal Note
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Removal Note

  1. Disconnect the negative battery cable.
  2. Remove the front door trim panel. See DOOR TRIM PANEL FRONT REMOVAL/INSTALLATION .
  3. Remove the watershield.
  4. Support the door glass.
  5. If equipped, disconnect the power window motor electrical connector.
    Fig 1: Disconnecting Power Window Motor Electrical Connector
    G01937219Courtesy of MAZDA MOTORS CORP.
  6. Loosen the center door glass run retainer.
    • Remove the center door glass run retainer nuts.
    Fig 2: Removing Center Door Glass Run Retainer Nuts
    G01937220Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Use a drift punch to remove the steel centers and a 6.35 mm (1/4 in) diameter drill bit to remove the rivets.
    NOTE:
    • The power window regulator has four rivets; the manual window regulator has three.
  7. Remove the window regulator rivets.
    1. Remove the steel centers.
    2. Remove the rivets.
    Fig 3: Locating Window Regulator Rivets
    G01937221Courtesy of MAZDA MOTORS CORP.
  8. Remove the window regulator.
    Fig 4: Removing Window Regulator
    G01937222Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Prior to motor removal, ensure the regulator arms are in a fixed position to prevent counterbalance spring unwind.
  9. If necessary, remove the motor.
    1. Remove the bolts.
    2. Remove the power window motor.
    Fig 5: Identifying Power Window Motor
    G01937223Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals