Control Valve Body Installation
CONTROL VALVE BODY INSTALLATIONOn-Vehicle Installation
Caution:
^ Do not move the manual valve in the direction of arrow to prevent the pin for manual valve rotation prevention from falling from the control valve body.
1. Align the manual valve and the manual plate and install the control valve body.
2. Install the installation bolts and connect the connectors.
Tightening torque 6.9 - 8.8 Nm (71 - 89 kgf-cm, 62 - 77 inch lbs.)
3. Install the oil pan and a new gasket to a new oil pan installation bolts.
Tightening torque 7.0 - 9.0 Nm (72 - 91 kgf-cm, 63 - 78 inch lbs.)
4. Connect the negative battery cable.
5. Install the battery cover.
6. Install the engine cover.
7. Add ATF and, with the engine idling, inspect the ATF level and inspect for leakage.
8. Perform the mechanical system test.
9. Perform the road test.