October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Removal and Installation
- Disconnect the negative battery cable. See BATTERY DISCONNECT
.
Courtesy of MAZDA MOTORS CORP.
- Remove the screws and remove the accelerator control splash shield.
Courtesy of MAZDA MOTORS CORP.
- Disconnect the throttle position (TP) sensor electrical connector.
Courtesy of MAZDA MOTORS CORP.
- Remove the two screws and the TP sensor.
NOTE:
- Failure to install the throttle position sensor in this manner may result in excessive idle speeds. Slide the rotary tangs into position over the throttle shaft blade, then rotate the throttle position sensor.
- To install, reverse the removal procedure.