July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

DTC P0011 .: Notes

DTC P0011 [L3] CHART

DTC P0011

CMP Timing over-advanced

DETECTION CONDITION

The actual valve timing is over-advanced by 17° from the target valve timing when the OCV is controlled in the maximum valve timing retard condition.
Monitoring condition
- Engine speed is below 4,000 RPM
- Engine coolant temperature is 70-110°C {158-230°F}

Diagnostic support note

This is a continuous monitor (CCM).
MIL illuminates if the PCM detects the above malfunction condition in during first drive cycle.
PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
FREEZE FRAME DATA is available.
The DTC is stored in the PCM memory.

POSSIBLE CAUSE

Oil control valve (OCV) malfunction
Spool valve in OCV is stuck in advance position
Variable valve timing actuator is stuck in advance position
Loose timing chain or improper valve timing due to timing chain slippage
PCM malfunction