LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> 5 Sport, 2.3 L, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3) >> DTC P0222 >> Diagnostic Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Diagnostic Procedure

DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT THROTTLE BODY CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the throttle body connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to Step 8.
No Go to the next step.
4 INSPECT TP SENSOR NO.2 CIRCUIT FOR SHORT TO BODY GROUND 
  • Turn the ignition switch off.
  • Inspect for continuity between the following circuits:
    • Throttle body terminal B and body ground
    • Throttle body terminal C and body ground
  • Is there continuity?
 Yes Repair or replace the wiring harness for a possible short to body ground, then go to Step 8.
No Go to the next step.
5 INSPECT TP SENSOR NO.2  Yes Replace the throttle body, then go to Step 8.
(See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
No Go to the next step.
6 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to Step 8.
No Go to the next step.
7 INSPECT TP SENSOR NO.2 CIRCUIT FOR OPEN CIRCUIT 
  • Turn the ignition switch off.
  • Inspect for continuity between the following terminals:
    • Throttle body terminal B and PCM terminal 2K
    • Throttle body terminal C and PCM terminal 21
  • Is there continuity?
 Yes Go to the next step.
No Repair or replace the wiring harness for a possible open circuit, then go to the next step.
8 VERIFY TROUBLESHOOTING OF DTC P0222 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine.
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
9 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals