LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> 5 Sport, 2.3 L, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3) >> DTC P0500 >> Notes
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

DTC P0500: Notes

DTC P0500 [L3] CHART

DTC P0500 VSS circuit problem
DETECTION CONDITION 
  • Wheel speed signal from ABS HU/CM is invalid value when following conditions are met:
    • Shift range in except P, N or R range (ATX)
    • Neutral switch and clutch switch are OFF (MTX)
    • Load is above 40% 
    • Engine speed is 2,000 RPM or above 
    • Brake switch is OFF

    • Diagnostic support note 

  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Front ABS wheel-speed sensor malfunction
  • ABS HU/CM malfunction
  • Connector or terminal malfunction
  • PCM malfunction
scientia non olet · About LEMON Manuals