October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Variable Tumble Control Operation Inspection

Connect the WDS or equivalent to the DLC-2.
Access ECT PID.
Verify that ECT PID is below 60 °C {140 °F} .
Start the engine.
Inspect rod operation under the following conditions:

Rod operation

ROD OPERATION REFERENCE CHART

Engine speed	3,750 RPM
Engine speed	Below	Above
Shutter valve actuator	Operate	Not operate

If the rod operation is not specified, inspect as follows:
1. Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
  - If DTC No. P2004, P2006, P2009 or P2010 are shown, perform DTC inspection.
    (See DTC TABLE ).
2. Inspect the variable tumble solenoid valve.
  (See VARIABLE TUMBLE SOLENOID VALVE INSPECTION ).
  - If the variable tumble solenoid valve is not normal, replace the variable tumble solenoid valve.
    (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ).
  - If the variable tumble solenoid valve is normal, inspect the following:
    - Vacuum hose and vacuum chamber for looseness or damage
    - Shutter valve actuator
      (See VARIABLE TUMBLE SHUTTER VALVE ACTUATOR INSPECTION ).
    - Shutter valve stuck open or closed