LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> 6 s, 4D Hatchback, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System (AJ) >> Camshaft Position (CMP) Sensor Inspection >> Resistance Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Resistance Inspection

  1. Disconnect the negative battery cable.
  2. Disconnect the CMP sensor connector.
  3. Measure the resistance between the CMP sensor terminals A and B using an ohmmeter.
    • If the CMP sensor is okay, but the PID value is out of specification, perform the "Circuit Open/Short Inspection".
    • If not as specified, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION ).

      Specification 

      467-571 ohms 

      Fig 1: Identifying CMP Sensor Connector Terminals
      G04325344Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals