Crankshaft Position (CKP) Sensor Removal / Installation - 2.3L: Removal

With the vehicle in NEUTRAL, position it on a hoist. See LIFTING .
Disconnect the negative battery cable. See BATTERY DISCONNECT .

Fig 1: Disconnecting Crankshaft Position Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Disconnect the crankshaft position (CKP) sensor electrical connector.

Fig 2: Removing Plug
Courtesy of MAZDA MOTORS CORP.
Remove the plug for the crankshaft timing peg SST.

Fig 3: Installing Special Tool And Turn Crankshaft Pulley
Courtesy of MAZDA MOTORS CORP.
Install the special tool and turn the crankshaft pulley bolt to position the number one cylinder at top dead center.

Fig 4: Locating CKP Sensor
Courtesy of MAZDA MOTORS CORP.
Install the M6 bolt (1F2012-428).
NOTE:
- A new CKP sensor must be installed when ever the old sensor is removed.
Remove the CKP.

Fig 5: Installing M6 Bolt
Courtesy of MAZDA MOTORS CORP.
Install an M6 bolt.