Engine Mount Member Installation Note

1. Position the direction indicator on engine mount member bushings facing toward the front side, and install the bushings onto the engine mount member.
   Fig 1: Identifying Engine Mounting Rubber

   Courtesy of MAZDA MOTORS CORP.
2. To install the engine mount member, put the No. 2 engine mount stud bolts through the engine mount member installation holes.
3. Install the engine mount member bolts A and nuts A.

   Tightening torque 

   A: 64-89 N.m {6.5-9.1 kgf.m, 47-65 ft.lbf} 

4. Loosely tighten the No. 2 engine mount nuts B and C.
5. Remove the SSTs  (engine support).
6. Tighten the No. 2 engine mount nuts B and C.
   Fig 2: Identifying Engine Mount Nuts B & C

   Courtesy of MAZDA MOTORS CORP.

Tightening torque 

B: 67-93 N.m {6.8-9.5 kgf.m, 50-68 ft.lbf} 

C: 85-116 N.m {8.7-11.9 kgf.m, 63-85 ft.lbf} 

Torque Converter Nuts Installation Note 

1. Align the holes by turning torque converter.
2. Insert a screwdriver from the starter installation hole, and lock the drive plate.
   CAUTION:

   • Loosely and equally tighten the torque converter nuts, then further tighten them to the specified tightening torque.
3. Tighten the torque converter mounting nuts.

   Tightening torque 

   34-61 N.m {3.5-6.2 kgf.m, 25-45 ft.lbf} 

   Fig 3: Tightening Torque Converter Mounting Nuts

   Courtesy of MAZDA MOTORS CORP.