Ignition Switch Inspection
- Remove the ignition switch. See REMOVAL AND INSTALLATION .
- Inspect for continuity between the ignition switch terminals using an ohmmeter.INSPECTION CHART
Circuit to test Connect self-powered test light or ohmmeter to terminals Move key to these positions A good switch will indicate Run/Start power circuit 4 and 1 Off/Lock Open circuit Accessory Open circuit Run Closed circuit Start Closed circuit Run/Ace power circuit 4 and 6 Off/Lock Open circuit Accessory Closed circuit Run Closed circuit Start Open circuit Start power circuit 4 and 7 Off/Lock Open circuit Accessory Open circuit Run Open circuit Start Closed circuit - If not as specified, replace the ignition switch.