LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC] >> DTC P0102 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P0102 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform the repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT MAF SENSOR CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the MAF/IAT sensor connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace terminals, then go to Step 8.
No Go to the next step.
4 INSPECT POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT 
  • Turn ignition switch to the ON position (Engine off).
  • Inspect voltage at MAF/IAT sensor terminal A (harness-side).
  • Is voltage B+  ?
 Yes Go to the next step.
No Inspect for an open circuit in the wiring harness between MAF/IAT sensor terminal A (harness-side) and the main relay.
Repair or replace the wiring harness, then go to Step 8.
5 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Disconnect the PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair terminal, then go to Step 8.
No Go to the next step.
6 INSPECT MAF SENSOR SIGNAL CIRCUIT FOR OPEN CIRCUIT 
  • Remove the PCM with the PCM connector connected.
  • Inspect for continuity between MAF/IAT sensor terminal C (harness-side) and PCM terminal 1P (harness-side).
  • Is there continuity?
 Yes Go to the next step.
No Repair or the replace suspected wiring harness, then go to Step 8.
7 INSPECT MAF SENSOR SIGNAL CIRCUIT FOR SHORT CIRCUIT 
  • Inspect for continuity between the MAF/IAT sensor terminal C (harness-side) and body ground.
  • Is there continuity?
 Yes Repair or replace the suspected harness, then go to the next step.
No Replace the MAF/IAT sensor, then go to the next step.
8 VERIFY TROUBLESHOOTING OF DTC P0102 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine and warm it up completely.
  • Is the same DTC present?
 Yes Replace PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
9 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About LEMON Manuals