LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC] >> DTC P0107 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P0107 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Recorded FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform the repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY MAP PID WHEN MAP SENSOR CONNECTOR IS DISCONNECTED 
  • Disconnect the MAP sensor connector.
  • Is the voltage above 4.9 V? 
 Yes Go to the next step.
No Go to step 5.
4 INSPECT POWER SUPPLY CIRCUIT VOLTAGE AT MAP SENSOR CONNECTOR 
NOTE:
  • If DTC P0122 and P2228 are also retrieved with P0107, go to the CONSTANT VOLTAGE troubleshooting procedure.

  • Turn ignition switch to the ON position (Engine off).
  • Measure voltage between MAP sensor terminal C (harness-side) and body ground.
  • Is the voltage within 4.5-5.5 V  ?
 Yes Check for a poor connection of MAP sensor terminal C (harness-side).
  • Repair or replace the terminal if necessary.
  • If normal, replace the MAP sensor.

Then go to Step 7.
No Check for an open circuit between PCM terminal 2K (harness-side) and MAP sensor terminal C (harness-side). Repair or replace the suspected wiring harness, then go to Step 7.
5 INSPECT MAP SENSOR SIGNAL CIRCUIT FOR SHORT TO GROUND 
  • Turn the ignition switch off.
  • Disconnect the PCM connector.
  • Inspect for continuity between MAP sensor terminal D (harness-side) and body ground.
  • Is there continuity?
 Yes Repair or replace the suspected wiring harness, then go to Step 7.
No Go to the next step.
6 INSPECT MAP SENSOR SIGNAL AND GROUND CIRCUIT FOR SHORT EACH OTHER 
  • Check for continuity between MAP sensor terminals D and A (harness-side).
  • Is there continuity?
 Yes Repair or replace the suspected wiring harness, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P0107 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start engine and warm it up completely.
  • Is same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About LEMON Manuals