Knock Sensor (KS) Removal/Installation
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery cover.
- Remove the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
- Remove the dynamic chamber. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
- Disconnect the KS connector.
- Remove the KS installation bolt, then remove the KS.
- Install in the reverse order of removal.
KS tightening torque
16-24 N.m {1.7-2.4 kgf.m, 12-17 ft.lbf}