Manifold Absolute Pressure (Map) Sensor Removal/Installation

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Remove the battery cover.
Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
Remove the dynamic chamber. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
Remove the MAP sensor.

Fig 1: Removing Manifold Absolute Pressure Sensor
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.
MAP sensor tightening torque

2.7-3.7 N.m {28-37 kgf.cm, 24-32 in.lbf}