LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> External Pages >> Different car >> Section 666 (Security System And Locks System) >> Front Outer Handle Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Outer Handle Removal/Installation

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (Vehicles with power window system or power outer mirror)
  2. Fully roll up the front door glass.
  3. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
  4. Remove the regulator handle. (Vehicles with manual window system) (See REGULATOR HANDLE REMOVAL .) (See REGULATOR HANDLE INSTALLATION .)
  5. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
  6. Remove the hole cover.
  7. Remove the nut, then remove the pad.
  8. Remove the bolt.
  9. Detach the rod from the outer handle.
    Fig 1: Front Outer Handle & Torque Specification
    G04956834Courtesy of MAZDA MOTORS CORP.
  10. Secure the rear part of the front outer handle and, with the front outer handle lever pulled outward (1), remove the rear part of the front outer handle from the front door.
  11. Pull out the front side of the front outer handle from the front door.
  12. Install in the reverse order of removal.
    Fig 2: Identifying Rear Part Of Front Outer Handle At Front Door
    G04928865Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals