LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> CX-9 Touring, 3.5 C, AWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Rear Power Window Regulator Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Power Window Regulator Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Inner sail garnish (See INNER SAIL GARNISH REMOVAL/INSTALLATION .)
    2. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
    3. Rear door speaker (See REAR DOOR SPEAKER REMOVAL/INSTALLATION .)
    4. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
    5. Power window motor (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
  3. Remove the nuts.
    Fig 1: Power Window Motor, Connector And Nuts With Torque Specifications
    G04971112Courtesy of MAZDA MOTORS CORP.
  4. Insert a hand through the speaker installation hole, rotate the drum housing in the direction shown in the figure to detach the tabs from the rear door unit.
    Fig 2: Rotating Drum Housing
    G04971113Courtesy of MAZDA MOTORS CORP.
  5. Move the rear power window regulator in the direction of the arrow and remove it.
  6. Install in the reverse order of removal.
    CAUTION:
    • Make sure the cable does not unspool from the drum housing when installing.
    Fig 3: Removing Rear Power Window Regulator
    G04971114Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals