Interlock Cable Installation Note

Push the interlock cable.

Fig 1: Pushing Interlock Cable
Verify that the marking on the slider pin is positioned as shown in the figure.

Fig 2: Identifying Lock Unit And Bracket
Push the a 1.5mm {0.059 in} round bar or similar into hole A by fully pushing the slider pin in.

Fig 3: Identifying Lock Unit And Brake Switch
Fully pull the end of the interlock cable.

Fig 4: Pulling End Of Interlock Cable
Push the a 1.5mm {0.059 in} round bar or similar into hole B and hole C of the lock unit until it passes through.
Disconnect the brake switch connector.
Remove the brake switch. (see BRAKE PEDAL REMOVAL/INSTALLATION .)
Install a new brake switch. (see BRAKE PEDAL REMOVAL/INSTALLATION .)
CAUTION:
- Do not connect the brake switch connector until the interlock cable is installed.
Fig 5: Identifying Lock Unit And Brake Switch
With the slider pin pressed, slide the lock unit to fix the lock unit hook into the bracket hole securely as shown in the figure.
CAUTION:
- Allowing the interlock cable to be bent or twisted during installation can affect the lock unit operation.
Rotate the slider pin to release the lock and verify that it slides freely.

Fig 6: Pressing Slider Pin
Pull the slider pin outward until it contacts the brake pedal stopper rubber and rotate the slider pin to lock.
Verify that the selector lever is in the P position.

Fig 7: Pulling Slider Pin Outward
Install the interlock cable end to the cam pin on the selector lever.
Fit the interlock cable in the U-groove in the selector lever base plate and install the clip.

Fig 8: Identifying Interlock Cable And Clip
Press the interlock cable lock piece in until it is locked.
CAUTION:
- Applying a load to the interlock cable while pressing the lock piece in can affect the lock unit operation.
Fig 9: Identifying Interlock Cable Lock And Unlock Position
Remove the a 1.5mm {0.059 in} round bar or similar from the lock unit holes A, B, and C.

Fig 10: Identifying Lock Unit And Slider Pin
Connect the brake switch connector with the brake pedal released.
CAUTION:
- The clearance between the brake switch and the brake pedal is automatically adjusted to the correct amount when the brake switch connector is connected after the brake switch has been properly installed. If the brake switch is not properly installed or the connector is connected before installation, the clearance may be incorrect, causing a brake fight malfunction. Therefore, always verify that the brake switch is properly installed before connecting the connector.
- Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again. Therefore, replace the switch with a new one when replacing the power brake unit or the pedal, or performing any procedure that changes the pedal stroke.
Turn the ignition switch to ON position.
Install the interlock cable to the steering lock.
Slide the outer casing to the steering lock and insert the clip over the convex part of the outer casing.

Fig 11: Inserting Clip Over Convex Part Of Outer Casing