Pcm Configuration

Connect the M-MDS or equivalent to the DLC-2.
Set up the M-MDS or equivalent (including the vehicle recognition).
Select "Module Programming".
Select "Programmable Module Installation".
Select "PCM" and perform procedures according to directions on the M-MDS or equivalent screen.
NOTE:
- If the PCM is replaced with a new one, the PCM stores DTC P0602 and illuminates the MIL even though no malfunction is detected. This means the PCM has not been configured yet.
  
  Fig 1: Locating DLC-2 Connector
  Courtesy of MAZDA MOTORS CORP.
Retrieve DTCs using the M-MDS or equivalent and verify that there is no DTC present.
- If any DTC is present, perform applicable DTC inspection. (See DTC TABLE. )