LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2008 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System >> Brake Fluid Pressure Sensor Initialization Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Brake Fluid Pressure Sensor Initialization Procedure

WARNING:
  • If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Chassis".
      2. Select "ABS/DSC".
      3. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "ABS".
      3. Select "DataLogger".
      4. Select "MCYL_S_CAL".
  4. Perform the initialization procedure according to the directions on the screen.
  5. Drive the vehicle.
  6. After 5 min or more  of driving, verify that the DSC system is normal.
    Fig 1: Identifying DLC-2 Connector
    G04955736Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals