Shift Interlock: Adjustments

SELECTOR CABLE ADJUSTMENT
1. Remove the following parts:
1) Side wall.
2) Heat insulator (front and center).
3) Selector lever knob and indicator component.
4) Center console.
2. Shift the selector lever to the P position.





3. Loosen the nut of the selector cable end (selector lever component side).
4. Verify that the manual shaft is in the P position.
5. Install the nut of the selector cable end in such a way that the selector lever does not bear a load.
Tightening torque 10-15 N-m (102-152 kgf-cm, 89-132 in-lbf)





6. Verify that the selector lever bolt end is exposed from the nut.
7. Install in the reverse order of removal.
8. Shift the selector lever from the P position to M range, and make sure that there are no other components in that area to interfere with the lever.