Pcm Configuration

WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.
After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select the "Module Programming".
- When using the PDS (Pocket PC)
  - Select "Programming".
  - Select "Module Programing".
Then, select the "Programmable Module Installation" and "PCM" from the screen menu.
Select "PCM" and perform procedures according to directions on the M-MDS screen.
Retrieve DTCs using the M-MDS, then verify if DTCs are present.
NOTE:
- If a DTC is present, perform the applicable DTC inspection.
  
  Fig 1: Locating DLC-2 Connector
  Courtesy of MAZDA MOTORS CORP.