Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/BOOST AIR TEMPERATURE SENSOR REMOVAL/INSTALLATION[L3 WITH TC]
1. Disconnect the negative battery cable.
2. Remove the charge air cooler duct.
3. Remove the oil level gauge pipe.
4. Disconnect the MAP/boost air temperature sensor connector.




5. Remove MAP/boost air temperature sensor from the intake manifold.
6. Install in the reverse order of removal.

Tightening torque
5.0 - 7.0 N.m (51 - 71 kgf.cm, 45 - 61 in.lbf)