DSC Related Part Sensor Initialization Procedure

DSC Related Part Sensor Initialization Procedure

Warning
^ If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, when replacing or removing the following parts, make sure to perform the initialization procedure to insure proper DSC operation.

1. When replacing or removing the following parts, perform the initialization procedure. (See COMBINED SENSOR INITIALIZATION PROCEDURE.) Programming and Relearning (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.) (See STEERING ANGLE SIGNAL INITIALIZATION PROCEDURE.) Steering Angle Sensor Initialization Procedure Steering Angle Signal Initialization Procedure
- DSC HU/CM
- Combined sensor
- Steering angle sensor