Removal and Installation

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When the PCM is replaced, the new PCM must be programmed with the old module's configuration information. See POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING - WDS .

Disconnect the negative battery cable. See BATTERY DISCONNECT .
Remove the powertrain control module (PCM) cover.
- Loosen the bolt and disconnect the electrical connector.
- Remove the nuts and the cover.
Remove the PCM.
To install, reverse the removal procedure.