LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2009 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Sliding Door Glass Removal/Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Sliding Door Glass Removal/Installation

  1. Fully open the sliding door glass.
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  3. Disconnect the negative battery cable.
  4. Remove the side door garnish. (See SIDE DOOR GARNISH REMOVAL/INSTALLATION .)
  5. Remove the rear side trim. (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
  6. Remove the sliding door trim. (See SLIDING DOOR TRIM REMOVAL/INSTALLATION .)
  7. Remove the bolt and screw.
    Fig 1: View Of Bolt, Screw With Torque Specifications
    G05545657Courtesy of MAZDA MOTORS CORP.
  8. Remove the rear door glass guide and glass run channel as a single unit.
  9. Connect the negative battery cable.
  10. Connect the power window sub switch connector.
    Fig 2: View Of Door Glass Guide And Glass Run Channel
    G05545658Courtesy of MAZDA MOTORS CORP.
  11. Adjust the door glass position as shown in the figure.
  12. Remove the hole cover.
    Fig 3: Adjusting Door Glass Position
    G05545659Courtesy of MAZDA MOTORS CORP.
  13. Remove the bolt.
  14. Lift the sliding door glass up and remove it by sliding it to the vehicle rear.
  15. Install in the reverse order of removal.
    Fig 4: View Of Window Bolt And Hole Cover
    G05545660Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals