LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2009 >> 6 s Touring >> Repair and Diagnosis >> General Information >> DTC Index >> Body Control System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Control System

DTC TABLE (BCM)

DTC No. Description Detection condition Refer to
B1D35:11 Hazard warning switch circuit malfunction Short to ground detected in hazard warning switch circuit with the hazard warning switch off See DTC B1D35:11 [BCM] .
B1D36:11 Turn switch circuit malfunction Short to ground detected in turn switch circuit with the turn switch off See DTC B1D36:11 [BCM] .
B10D0:11 Trunk lid opener switch (vehicle exterior) circuit malfunction Short to ground detected in trunk lid opener switch (vehicle exterior) circuit with the ignition switch ON See DTC B10D0:11 [BCM] .
B1048:11 Brake fluid level sensor circuit malfunction Short to ground in brake fluid level sensor circuit with the brake fluid amount on the upper side of the minimum See DTC B1048.11 [BCM] .
B1079:13 Hood latch switch circuit malfunction Open circuit detected in hood latch switch circuit with the hood closed (hood latch switch on) See DTC B1079:13 [BCM] .
B108F:16 Door lock switch circuit malfunction The voltage of door lock switch circuit is less than 3.75 V  with the door lock switch off See DTC B108F:16 [BCM] .
B11C0:13 Rear door latch switch (driver-side) circuit malfunction Open circuit detected in rear door latch switch (driver-side) circuit with the rear door (driver-side) closed {rear door latch switch (driver-side) on} See DTC B11C0:13 [BCM] .
B11C1:13 Rear door latch switch (passenger-side) circuit malfunction Open circuit detected in rear door latch switch (passenger-side) circuit with the rear door (passenger-side) closed {rear door latch switch (passenger-side) on} See DTC B11C1:13 [BCM] .
B11DA:11 Front door key cylinder switch (driver-side) circuit malfunction Short to ground detected in front door key cylinder switch (driver-side) circuit with the front door key cylinder switch (driver-side) off See DTC B11DA:11 [BCM] .
B113E:11 Trunk lid opener switch (vehicle interior) circuit malfunction Short to ground in trunk lid opener switch (vehicle interior) circuit with the trunk opener switch off See DTC B113E:11 [BCM] .
B1172:11 Front door lock-link switch (driver-side) circuit malfunction Short to ground detected in front door lock-link switch (driver-side) lock-side circuit with the front door lock-link switch (driver-side) unlocked See DTC B1172:11 [BCM] .
B1172:13 Front door lock-link switch (driver-side) circuit malfunction Open circuit detected in front door lock-link switch (driver-side) unlock-side circuit with the front door lock-link switch (driver-side) unlocked See DTC B1172:13 [BCM] .
B1174:1 Door lock-link switch circuit malfunction Open circuit detected in door lock-link switch circuit with the door lock-link switch unlocked See DTC B1174:13 [BCM] .
B1175:13 Front door latch switch (driver-side) circuit malfunction Open circuit detected in front door latch switch (driver-side) circuit with the front door (driver-side) closed (front door latch switch {driver-side} on) See DTC B1175:13 [BCM] .
B1176:13 Front door latch switch (passenger-side) circuit malfunction Open circuit detected in front door latch switch (passenger-side) circuit with the front door (passenger-side) closed (front door latch switch {passenger-side} on) See DTC B1176:13 [BCM] .
B1178.11 Trunk lid latch switch circuit malfunction Short to ground detected in trunk lid latch switch circuit with the trunk closed (trunk lid latch switch off) See DTC B1178:11 [BCM] .
C0051:04 Steering angle sensor internal malfunction
  • Z phase is abnormal
  • Detected steering angle exceeds the specified value
 See DTC C0051.04 [BCM] .
C0051:2F Steering angle sensor signal error Detected error in a combination of signals from each sensor (A, B, C, D) See DTC C0051:2F/C0052:11/ C0052:13/C0053:11/ C0053:13/C0054:11/ C0054.13/C0055:11/ C0055:13 [BCM] .
C0052.1 Steering angle sensor A signal input circuit error The voltage lower than the specification is detected for 0.1 s 
C0052:1 The voltage higher than the specification is detected for 0.1 s 
C0053.1 Steering angle sensor B signal input circuit error The voltage lower than the specification is detected for 0.1 s 
C0053:13 The voltage higher than the specification is detected for 0.1 s 
C0054:11 Steering angle sensor C signal input circuit error The voltage lower than the specification is detected for 0.1 s 
C0054:13 The voltage higher than the specification is detected for 0.1 s 
C0055:11 Steering angle sensor D signal input circuit error The voltage lower than the specification is detected for 0.1 s 
C0055:13 The voltage higher than the specification is detected for 0.1 s 
C1137.12 L5/ATX 
  • Transaxle range switch circuit malfunction

L5/MTX 
  • Back-up light switch circuit malfunction

MZI-3.7 
  • Back-up light relay circuit malfunction
 L5/ATX 
  • Short to power supply in transaxle range switch circuit with the selector lever in P or N position (transaxle range switch on)

L5/MTX 
  • Short to power supply in back-up light switch circuit with the shift lever in N position (back-up light switch on)

MZI-3.7 
  • Short to power supply in back-up light relay circuit with the selector lever in P or N position
 See DTC C1137:12 [BCM] .
P1536:13 Parking brake switch circuit malfunction Open circuit detected in parking brake switch circuit with the parking brake lever applied (parking brake switch on) See DTC P1536:13 [BCM] .
U0001:88 Unit communication error (HS-CAN) CAN system error with BCM See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .
U0100:00 PCM communication error Communication error between PCM and BCM
U0101:00 TCM communication error Communication error between TCM and BCM
U0151:00 SAS control module communication error Communication error between SAS control module and BCM
U0214.00 Keyless control module communication error Communication error between keyless control module and BCM
U0300.00 BCM configuration setting invalid
CAUTION:
  • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
  • BCM configuration setting not done correctly
 See DTC U0300:00 [BCM] .
U0401.68 Signal error from PCM Correct data cannot be received from PCM See DTC U0401 68 [BCM] .
U0402:68 Signal error from TCM Correct data cannot be received from TCM See DTC U0402.68 [BCM] .
U2100:00 BCM configuration not set
CAUTION:
  • Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When performing an inspection, always follow the inspection procedure.
  • BCM configuration setting not done correctly
 See DTC U2100:00 [BCM] .
U3000:04 BCM internal malfunction BCM internal ECU is faulted See DTC U3000:04 [BCM] .
U3003:16 BCM power supply circuit malfunction BCM power supply voltage low less than 10 V  . See DTC U3003:16/U3003:17 [BCM] .
U3003.17 BCM power supply voltage high more than 16 V  .
scientia non olet · About LEMON Manuals