Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]

Disconnect the negative battery cable.
Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
Detach the tab.

Fig 1: Identifying Ignition Switch And Tab
Courtesy of MAZDA MOTORS CORP.
Pull the pin in the direction of the arrow shown in the illustration and release the lock.

Fig 2: Identifying Ignition Switch, Connector And Lock Lever
Courtesy of MAZDA MOTORS CORP.
Disconnect the ignition switch connector and key interlock solenoid connector.

Fig 3: Identifying Ignition Switch Connector And Key Interlock Solenoid Connector
Courtesy of MAZDA MOTORS CORP.
Remove the tabs.

Fig 4: Identifying Tab And Ignition Switch
Courtesy of MAZDA MOTORS CORP.
Remove the ignition switch from the steering shaft.
Install in the reverse order of removal.