LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2010 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass/Windows/Mirrors >> Rear Power Window Regulator Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Power Window Regulator Removal/Installation

  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
  2. Disconnect the negative battery cable.
  3. Remove the following parts:
    1. Remove the side door garnish (See SIDE DOOR GARNISH REMOVAL/INSTALLATION .)
    2. Remove the rear side trim (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
    3. Sliding door trim (See SLIDING DOOR TRIM REMOVAL/INSTALLATION .)
    4. Sliding door glass (See SLIDING DOOR GLASS REMOVAL/INSTALLATION .)
    5. Rear power window motor (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
  4. Remove the nuts.
    Fig 1: Rear Power Window Regulator Nut With Torque Specifications
    G05545667Courtesy of MAZDA MOTORS CORP.
  5. Insert a hand through the service hole, rotate the drum housing in the direction shown in the illustration and disengage the tabs from the sliding door module panel.
    Fig 2: Inserting Hand Through Service Hole
    G05545668Courtesy of MAZDA MOTORS CORP.
  6. Take the rear power window regulator out through the service hole.
  7. Install in the reverse order of removal.
    CAUTION:
    • Make sure the cable does not unspool from the drum housing when installing.
      Fig 3: Identifying Rear Window Regulator
      G06762271Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals