LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2010 >> 5 Touring, 2.3 L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System [L3] >> Clutch Pedal Position (CPP) Switch Inspection >> Continuity Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Continuity Inspection

  1. Verify that the CPP switch is installed properly.
  2. Disconnect the negative battery cable.
  3. Disconnect the CPP switch connector.
  4. Verify that the continuity between CPP switch terminals A and B is as indicated in the table.
    • If there is no malfunction, perform the "Circuit Open/Short Inspection".
    • If there is any malfunction, replace the CPP switch.
      CONTINUITY MEASURED CONDITION

      Measurement condition Clutch pedal position Continuity
      Push the rod. Clutch pedal depressed Continuity detected
      Except above Clutch pedal released No continuity
      Fig 1: Inspecting Clutch Pedal Position Switch
      G05543219Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals