LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 3 >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Power Systems >> Starter Cut Relay Removal/Installation [MTX] >> Advanced Keyless Entry And Push Button Start System Only
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Advanced Keyless Entry And Push Button Start System Only

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    4. Console (See CONSOLE REMOVAL/INSTALLATION ).
  3. Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  4. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION ).
  5. Disconnect the connector.
    Fig 1: Disconnecting Starter Cut Relay Connector
    G06733190Courtesy of MAZDA MOTORS CORP.
  6. Remove the nut.
  7. Remove the starter cut relay.
  8. Install in the reverse order of removal.
    Fig 2: Removing Starter Cut Relay
    G06733190Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals