Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
- Disconnect the negative battery cable.
- Remove the generator. (See GENERATOR REMOVAL/INSTALLATION [13B-MSP] .)
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Disconnect the ECT sensor connector.
- Remove the ECT sensor.
- Install in the reverse order of removal.