No. 3 Additional Key Programming Procedure Changing: Procedure
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
KEY PROGRAMMING PROCEDURE
| Step |
Procedure |
Action after procedure |
| 1 |
CHANGE CUSTOMER SPARE KEY PROGRAMMING PROCEDURE
- Connect the M-MDS to the DLC-2. (See
M-MDS CONNECTING PROCEDURE .)
- Turn the ignition switch to the ON position using a key (The key can be either the valid key or an unprogrammed key.)
NOTE:
- If an unprogrammed key is used, the security light starts flashing and DTC 15 is displayed after approx. 1 min
. However, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
- After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC)
- Select the "Body"
- Select the "Security"
- Select the "PATS function"
- Using a PDS (Pocket PC):
- Select the "All Tests and Calibrations"
- Select the "PATS Functions"
- Select either of the following from the M-MDS menu to change the additional key programming procedure.
- When "Customer Spare Key Programming Enable" is selected: The additional key programming procedure using valid keys is enabled.
- When "Customer Spare Key Programming Disable" is selected: The additional key programming procedure using valid keys is disabled.
- Perform the security access according to the directions on the M-MDS screen.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
- Turn the ignition switch to the LOCK position.
|
Procedure is completed |