LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Control System [L3 With TC] >> Clutch Pedal Position (CPP) Switch Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Clutch Pedal Position (CPP) Switch Inspection

  1. Verify that the CPP switch is installed properly.
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] ).
  3. Disconnect the negative battery cable.
  4. Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION ).
  5. Inspect for continuity between the CPP switch terminals using an ohmmeter.
    SPECIFICATION

    Measured condition Clutch pedal position Continuity
    Rod pushed Clutch pedal released Continuity detected
    Except above Clutch pedal depressed No continuity
    Fig 1: Identifying CPP Switch Connector Terminals
    G07868459Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals