Neutral Switch Inspection
WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] .)
- Disconnect the negative battery cable.
- Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
- Inspect for continuity between the neutral switch terminals using an ohmmeter.
- If not as specified, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
CONTINUITY CHARTSpecification Measured condition Continuity Rod pushed Continuity detected Except above No continuity