Pcm Configuration

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to DLC-2.
After the vehicle is identified, select the following terns from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select the "Module Programming".
Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "PCM".
Perform the configuration according to the directions on the screen.
Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
- If a DTC (s) is detected, perform the applicable DTC inspection. (See DTC TABLE .)
  
  Fig 1: Identifying Data Link Connector (DLC-2)
  Courtesy of MAZDA MOTORS CORP.