Keyless Control Module Removal/Installation
WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- When replacing the keyless control module, perform the following procedure:
- Keyless Control Module Configuration (See KEYLESS CONTROL MODULE CONFIGURATION .)
- Immobilizer System-related Parts Programming [with advanced keyless system] (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH ADVANCED KEYLESS SYSTEM] )
- Immobilizer system-related parts programming [with keyless entry system] (See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING [WITH KEYLESS ENTRY SYSTEM] .)
- Disconnect the negative battery cable.
- Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Remove the nut and screw.
- Remove the connector clip installed to the bracket by shifting the keyless control module downward.
- Disconnect the keyless control module connector.
- Install in the reverse order of removal.