Power Outer Mirror Switch Inspection
- Switch the ignition ON.
- Verify that the power outer mirror switch can be operated for approx. 43 s
after the ignition is switched off.
- If the power outer mirror cannot be operated for approx. 43 s after the ignition is switched off, or if the power outer mirror can still be operated after approx. 43 s , replace the power outer mirror switch.
- Disconnect the negative battery cable.
- Remove the inner garnish, (driver-side) (See INNER GARNISH REMOVAL/INSTALLATION .)
- Remove the front door trim, (driver-side) (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
- Remove the switch panel, (driver-side) (See FRONT DOOR TRIM DISASSEMBLY/ASSEMBLY .)
- Using a tester, verify that the continuity between the power outer mirror switch terminals is as indicated in the table.
- If not as indicated in the table, replace the power outer mirror switch. (See POWER OUTER MIRROR SWITCH REMOVAL/INSTALLATION .)