Continuity Inspection
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
- Disconnect the negative battery cable.
- Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
- Verify that the continuity between neutral switch terminals A and B is as indicated in the table.
- If there is no malfunction, perform the "Circuit Open/Short Inspection". (See CIRCUIT OPEN/SHORT INSPECTION .)
- If there is any malfunction, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)
CONTINUITY REFERENCE CHART
| Measurement condition | Continuity |
|---|---|
| Push the rod | No continuity |
| Except above | Continuity detected |