Steering Angle Adjustment
- Loosen the locknut of the tie-rod end.
- Remove the rack boot clamp.
- Rotate the tie rod and adjust the steering angle.NOTE:
- The travel distance of the right and left tie rods should be the same.
- Rotate the tie rod and adjust so that the length L shown in the figure is within the specification.
- Standard
29.6-45.6 mm {1.17-1.79 in}
- Standard
- Tighten the locknut of the tie-rod end.
Tightening torque
- 69-98 N m {7.1-9.9 kgf m, 51-72 ft lbf}
- Correct the rack boot twists.
- Install and fix the rack boot clamp.
- After adjusting the steering angle, always inspect and adjust the toe angle.