Gear Sensor/Switch: Service and Repair

NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R]

1. Disconnect the negative battery cable.

2. Remove the battery component. (ex: battery, battery tray) Removal and Replacement

3. Remove the aerodynamic under cover. Service and Repair

4. Drain the manual transaxle oil. Manual Transaxle Oil Replacement

5. Remove the neutral switch and gasket.






Tightening torque
- 20-29 Nm {2.1-2.9 kgf-m, 15-21 ft-lbf}

6. Install in the reverse order of removal.

7. Add the specified amount and type of manual transaxle oil. Manual Transaxle Oil Replacement