SAS Control Module Configuration
- Connect the M-MDS (IDS) to DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- Select the "Module Programming".
- Select "Programmable Module Installation".
- Select menu in the "RCM".
- Perform the configuration according to the directions on the screen.
- Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
- If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE [STANDARD DEPLOYMENT CONTROL SYSTEM] .)(See DTC TABLE [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)